![]() ![]() This implies there's some other resource accessing, or trying to access, the device, however your device is mounted: df -h.Mount: mounting /dev/sda1 on /mnt failed: Resource busy Mount: mounting /dev/sda1 on /mnt failed: Resource df -hįilesystem Size Used Available Use% Mounted on dev/mtdblock3: MOUNT="/overlay" mount /dev/sda1 /mnt dev/mtdblock3: MOUNT="/overlay" mount /dev/sda1 block info I tried to mount again but still without success. I reformatted on of the device to exfat and started over from sysupgrade. Earlier I tried ext3 as well.ĭevices are working well on win10. * opkg_install_cmd: Cannot install package opkg install opkg install opkg install opkg install opkg install opkg install opkg install opkg install block detect * opkg_install_cmd: Cannot install package opkg install kmod-fs-ext3 ash: install: not opkg install kmod mod-fs-exfat ![]() Opkg: unknown sub-command install kmod mod-fs-exfat * pkg_hash_add_from_file: Failed to open /var/opkg-lists/reboot_routing: Out of opkg install kmod-usb-storage-extras Correct me if I wrong (I'm not an expert) but I think the drive must be first mounted and only after can be shared via SMB. Besides that the USB device still not mounted. If it is necessary I roll back the system to default. Unfortunately I went through your post line by line therefore I only have the output of block detect after the installations. I left out the successfully installed ones from the logs. The only thing wich was changed is the Device (and therefore its size) by SWAP at the Web GUIĬan somebody help me out what could be the problem? But by the next step I have no result.Īs far as I understand the drive wasn't mounted.Īccordingly there is not visible by Mount Points at the GUI but can be seen by SWAP. |_ Port 1: Dev 3, If 0, Class=Mass Storage, Driver=usb-storage, 480Mīrw- 1 root root 8, 0 Jan 1 21:43 /dev/sdaīrw- 1 root root 8, 1 Jan 1 21:43 /dev/sda1 : Bus 01.Port 1: Dev 1, Class=root_hub, Driver=ehci-platform/1p, 480M Opkg install kmod-usb-storage - successful Now I would like to attach and share a drive via USB. I was able to configure the basics on the web GUI. Little later I upgraded it with this: lede-17.01.4-ar71xx-generic-tl-wr842n-v2-squashfs-sysupgrade.bin. I recently installed openwrt-ar71xx-generic-tl-wr842n-v2-squashfs-factory.bin to my TL-WR842ND V2 router.
0 Comments
Leave a Reply. |